Fisher Paykel Washer Error Code no tAP

Encountering the tAP error code on your Fisher Paykel washer indicates a disruption in the water supply to the appliance.

Here’s a detailed guide to troubleshoot and resolve this issue:

1. Check Taps:

   Ensure that the water supply taps connected to your washer are fully turned on. Sometimes, a simple oversight in turning on the taps can lead to the tAP error.

2. Inspect Inlet Hose Filters:

   The inlet hose filters may accumulate debris over time, causing a blockage. To resolve this, locate the filters and clean them thoroughly. If cleaning doesn’t help, consider replacing the filters to restore the water flow.

3. Examine Hose for Kinks:

   A kink in the inlet hose can obstruct the water flow. Undo the hose, carefully removing any kinks, and then reattach it securely. If the hose is damaged, it’s advisable to replace it to prevent future issues.

4. Check Drain Hose Position:

   If the drain hose is positioned too low or pushed too far into the standpipe, it can lead to siphoning of water out of the washer. Adjust the height of the drain hose and ensure it is properly inserted into the standpipe to prevent drainage problems.

5. Evaluate Supply Water Flow:

   The tAP error may occur if the flow rate of the water supply is insufficient. Check the water pressure and ensure it meets the recommended levels for your Fisher Paykel washer. In case of slow flow, contact your water supplier to address the issue.

By following these steps, you can effectively troubleshoot and resolve the Fisher Paykel Washer Error Code tAP. Regular maintenance, such as cleaning filters and inspecting hoses, can contribute to the smooth operation of your washer, preventing future occurrences of this error.